In some car and truck entrances, the local conditions require an ingenious solution. Wherever space is limited but a wide entrance is needed, the telescopic sliding gate is the perfect choice.
Using three telescopic leaves reduces the required run back: The middle leaf is stacked between the two outer leaves which run parallel to one another. This can reduce the run back by up to 30 %, compared to a single leaf gate. Like all INOVA sliding gates, the telescopic sliding gate reaches an operating speed of up to 25 cm/s.
• solid steel construction with three telescopic gate leaves • needs up to 30 % less space than a single leaf gate system • wide clear opening of up to 18 meters, no bottom rail required • AC motor with a 100 % duty cycle, housed in the lower beam protected from weather and tampering • gate system is pre-assembled and ready for immediate operation
- Basic Specification
• three gate leaves with safety infills for reach-trough protection according to DIN EN ISO standard 13857 • 5 active safety contacts and 2 photoelectric switches for maximum accident prevention • drive power of up to 0.75 kW, integrated in the lower beam • maximum corrosion protection through galvanisation and double powder coating • available in all standard RAL colours (6005, 7016, 7030, 9010) and in Inometallic • high operating speed of 25 cm/s allows short opening and closing cycles
- Optional Extras
• programming, for example for interlock control, gate or barrier systems or traffic light control • different control options to choose from, for example via mobile phone or card reader • almost unlimited choice of special colours • flashing light or LED revolving signal beacon to signal gate movement • many more optional extras available - please contact us to find out more
The sliding movement of the leaves creates shearing edges on the telescopic sliding gate which require special protection. We recommend our customers to fully encase the run back area with a reach-through protection fence. High-quality gate infills prevent body limbs from reaching through any openings and thus minimize the risk of injury. The following infills are available: safety wire mesh sheets, sheet metal, perforated sheet metal or stainless-steel mesh. These options can also be combined. As goes for all INOVA sliding gates, safety is the highest priority. This means our telescopic sliding gate meets the safety requirements of DIN EN standard 12453.This standard specifies the necessity of five active safety contacts and two photoelectric switches.